Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052846 SEAT BELT _0255651 SEAT BELT WARNING SYSTEM Y

SEAT BELT  SEAT BELT WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the seat belt warning system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.


b.

Clear the DTCs.


c.

Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs.


Result:
Result Proceed to
DTC is not output A
CAN communication system DTC is output (for LHD with Central Gateway ECU) B
CAN communication system DTC is output (for LHD without Central Gateway ECU) C
CAN communication system DTC is output (for RHD with Central Gateway ECU) D
CAN communication system DTC is output (for RHD without Central Gateway ECU) E
Airbag system DTC is output F



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

E

F

4.PROBLEM SYMPTOMS TABLE
a.

Result:
Proceed to
NEXT



NEXT

5.OVERALL ANALYSIS AND TROUBLESHOOTING*
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END