Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (w/ Telematics Transceiver except G-BOOK) › from 2016.08
RM2660E _56 Audio / Visual / Telematics _052866 TELEMATICS _0283437 TELEMATICS SYSTEM(w/ Telematics Transceiver except G-BOOK) C

TELEMATICS  TELEMATICS SYSTEM(w/ Telematics Transceiver except G-BOOK)  B15C4  SRS Communication Error  


DESCRIPTION

If the telematics transceiver detects an error in communication between itself and the center airbag sensor assembly as a result of a self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C4 SRS Communication Error The telematics transceiver detects an error in signals from the center airbag sensor assembly when engine switch is on (IG).
·

Telematics transceiver

·

Center airbag sensor assembly

·

Harness or connector

·

Airbag system



WIRING DIAGRAM

E342824E26
1.208,0.833 1.823,1.031 0.615,0.198 10 false GSW3 5.531,0.854 6.146,1.052 0.615,0.198 10 false GSW 1.75,0.729 2.063,0.927 0.313,0.198 10 false 24 5.26,0.729 5.573,0.927 0.313,0.198 10 false 24 0.688,1.313 1.083,1.51 0.396,0.198 10 false E47 5.198,1.323 5.594,1.521 0.396,0.198 10 false P3 0.677,1.49 2.698,1.781 2.021,0.292 10 false Center Airbag Sensor Assembly 5.208,1.49 6.833,1.719 1.625,0.229 10 false Telematics Transceiver

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (w/ Telematics Transceiver except G-BOOK)>REGISTRATION

·

This vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.CHECK FOR DTC (AIRBAG SYSTEM)
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG) for 20 seconds.


d.

Turn the GTS on.


e.

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.INSPECT TELEMATICS TRANSCEIVER

B

2.INSPECT TELEMATICS TRANSCEIVER
a.
B240640C16
2.354,1.25 2.563,1.698 2.563,1.698 2.688,1.698 false 0.125,0.125 0.396,0.385 0.271,0.26 10 false *a 2.729,1.625 3.177,1.906 0.448,0.281 10 false GSW 0.208,4.031 0.646,4.292 0.438,0.26 10 false GND 0.167,2.26 0.438,2.521 0.271,0.26 10 false *b
*a Component with harness connected
(Telematics Transceiver)
*b Waveform


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
24 (GSW) - Body ground Engine switch on (IG) Pulse generation (Refer to waveform)


Reference Waveform:
Item Condition
Tester connection 24 (GSW) - Body ground
Tool setting 5.0 V/DIV., 20 ms/DIV.
Vehicle condition Engine switch on (IG)



Result:
Proceed to
OK
NG



OK

3.REPLACE TELEMATICS TRANSCEIVER

NG

4.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - CENTER AIRBAG SENSOR ASSEMBLY)
3.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - CENTER AIRBAG SENSOR ASSEMBLY)
a.

Disconnect the P3 telematics transceiver connector.


b.

Disconnect the E47 center airbag sensor assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
P3-24 (GSW) - E47-24 (GSW3) Always Below 1 Ω
P3-24 (GSW) or E47-24 (GSW3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR