This DTC is stored when the telematics transceiver detects an open or short circuit in the manual (SOS) switch.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C5 | Emergency Switch Error (Open or Short) | Open or short circuit in the manual (SOS) switch is detected. | ·
Telematics transceiver ·
Map light assembly (manual (SOS) switch) ·
Harness or connector |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT(for LH Side)>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 22 (SIG1) - 21 (GND3) | Manual (SOS) switch not pressed | 392 to 432 Ω |
| 22 (SIG1) - 21 (GND3) | Manual (SOS) switch pressed | 78 to 86 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the P3 telematics transceiver connector.
Disconnect the R7 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P3-27 (SIG1) - R7-22 (SIG1) | Always | Below 1 Ω |
| P3-27 (SIG1) or R7-22 (SIG1) - Body ground | Always | 10 kΩ or higher |
| P3-26 (SIG-) - R7-21 (GND3) | Always | Below 1 Ω |
| P3-26 (SIG-) or R7-21 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT