This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telematics transceiver or when the VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F0 | VIN Not Programmed or Mismatch - DCM | When either of the following conditions is met:
·
The VIN is not stored in the telematics transceiver. ·
The VIN stored in the telematics transceiver and the VIN stored in the ECM do not match. |
·
SFI system ·
ECD system ·
CAN communication system |
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and wait for 10 seconds.
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization
According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check if CAN communication system DTCs are output.
CAN communication system DTCs are not output.
| Result | Proceed to |
|---|---|
| OK (SFI SYSTEM) | A |
| OK (ECD SYSTEM) | B |
| NG | C |
A
B
C