Home › Audio / Visual / Telematics › TELEMATICS › MAYDAY SWITCH › from 2016.08
RM2660E _56 Audio / Visual / Telematics _052866 TELEMATICS _0287899 MAYDAY SWITCH G

TELEMATICS  MAYDAY SWITCH  INSPECTION  


PROCEDURE

Hide 81260A 1.REMOVE MAP LIGHT ASSEMBLY

Hide 81260A 2.INSPECT MAP LIGHT ASSEMBLY

a.

Check the resistance.

i.
E160634C01
2,1.375 1.302,0.76 true 2.125,1.375 2.521,0.781 true 0.063,0.042 0.375,0.24 0.313,0.198 10 false *a 0.979,0.667 1.594,0.865 0.615,0.198 10 false SIG1 2.552,0.698 3.167,0.896 0.615,0.198 10 false GND3
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Resistance:
Tester Connection Condition Specified Condition
22 (SIG1) - 21 (GND3) Mayday switch not pressed 410 to 414 Ω
22 (SIG1) - 21 (GND3) Mayday switch pressed 81 to 83 Ω




b.

Check the operation (indicator).

i.
E355201C01
1.667,0.563 1.667,0.24 1.667,0.24 1.302,0.24 false 2.49,2.49 2.875,2.833 true 1.771,2.5 1.771,2.844 true 1.635,2.479 1.292,2.823 true 0.083,0.073 0.396,0.271 0.313,0.198 10 false *a 1.135,0.177 1.448,0.375 0.313,0.198 10 false *b 2.771,2.865 3.229,3.052 0.458,0.188 10 false GND9 1.677,2.875 2.292,3.073 0.615,0.198 10 false IND2 1.125,2.865 1.74,3.063 0.615,0.198 10 false IND1
*a Component without harness connected
(Map Light Assembly)
*b Two 1.5 V dry cell batteries


Check that each indicator illuminates when 2 dry cell batteries are connected to the map light assembly connector terminals as shown in the illustration.

NOTICE:

Do not apply more than 3 V.


OK:
Tester Connection Condition Specified Condition
24 (IND1) - 17 (GND9) Positive (+) dry cell battery - Negative (-) dry cell battery HELP RED indicator illuminates
23 (IND2) - 17 (GND9) Positive (+) dry cell battery - Negative (-) dry cell battery HELP GREEN indicator illuminates




Hide 81260A 3.INSTALL MAP LIGHT ASSEMBLY