Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT › from 2016.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255750 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 68961F 1.INSTALL BACK DOOR STAY BOLT

a.

When replacing the back door stay bolt with a new one:

i.

Clean the threaded surface on the vehicle body with a non-residue solvent.



b.

When reusing the back door stay bolt:

i.

Clean the threaded surface on the vehicle body with a non-residue solvent.


ii.

Apply adhesive to the threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent




c.
B181317

Install the back door stay bolt.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)


Hide 68946 2.INSTALL BACK DOOR DAMPER STAY BRACKET UPPER LH

a.

When replacing the back door stay bracket upper LH with a new one:

i.

Clean the threaded surface on the vehicle body with a non-residue solvent.



b.

When reusing the back door stay bracket upper LH:

i.

Clean the threaded surface on the vehicle body with a non-residue solvent.


ii.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent




c.
B453533

Tighten the 2 bolts to install the back door damper stay bracket upper LH.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 68960 3.INSTALL BACK DOOR STAY ASSEMBLY LH

a.

When reusing the back door stay:

i.

Install the 2 stop rings to the back door stay assembly LH.



b.

Install the back door stay assembly LH to back door stay bracket upper LH.

NOTICE:

Check that the back door stay assembly is engaged in the ball joint and that the back door support assembly cannot be pulled out.



c.

Install the back door stay assembly LH to back door stay bolt.

NOTICE:

Check that the back door stay assembly is engaged in the ball joint and that the back door support assembly cannot be pulled out.