Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION FLUID › 2017.08–2020.06
RM2660E _52 Drivetrain _066407 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0323651 AUTOMATIC TRANSMISSION FLUID A

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE AUTOMATIC TRANSMISSION FLUID

a.

Lift the vehicle. [*1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/-1°).



b.
C382625

Remove the drain plug and gasket from the automatic transmission assembly and drain the automatic transmission fluid. [*2]


c.

Temporarily install the gasket and drain plug to the automatic transmission assembly. [*3]

HINT:

Reuse the old gasket as the drain plug will be removed again.



d.
C382626

Remove the refill plug and O-ring from the automatic transmission assembly. [*4]


e.
C382627

Using a 5 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transmission assembly. [*5]


f.
C382628C01
0.521,1.802 0.729,1.802 0.729,1.802 1.323,0.99 true 0.802,4.396 1,4.396 1,4.396 1.635,3.656 true 0.313,1.698 0.521,1.948 0.208,0.25 10 false *a 0.604,4.302 0.802,4.531 0.198,0.229 10 false *b
*a Refill Hole
*b Overflow Hole


Add automatic transmission fluid to the refill hole until it flows out of the overflow hole. [*6]

NOTICE:
·

Use Toyota Genuine ATF WS.

·

Be sure to add automatic transmission fluid slowly. If automatic transmission fluid is added quickly, the automatic transmission fluid may hit internal parts and bounce back, resulting in automatic transmission fluid coming out of the refill hole.




g.
C382629

Wait until the automatic transmission fluid flow slows and only drips come out. [*7]


h.
C382627

Using a 5 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transmission assembly. [*8]

HINT:

Reuse the old gasket as the overflow plug will be removed again.



i.

Add the amount of specified to the refill hole. [*9]

Specified Amount of Fluid:

2.4 liters (2.5 US qts, 2.1 Imp. qts)


HINT:

If the specified amount of automatic transmission fluid cannot be added, perform steps [*10] to [*15].



j.

Temporarily install the O-ring and refill plug to the automatic transmission assembly. [*10]

HINT:

Reuse the old O-ring as the refill plug will be removed again.



k.

Lower the vehicle. [*11]


l.

Start the engine. [*12]

NOTICE:

To reduce load, make sure that all electrical systems, such as the air conditioning, lighting system, electric fan and audio system, are off.



m.

Slowly move the shift lever from P to S, and then back to P. [*13]


n.

Allow the engine to idle for 30 seconds to warm it up. [*14]


o.

Turn the engine switch off. [*15]


p.

Repeat steps [*1] to [*15].


q.

Repeat steps [*1] to [*2].


r.

Install a new gasket and the drain plug to the automatic transmission assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


s.

Repeat steps [*4] to [*11].


Hide 5. ATF THERMAL DEGRADATION ESTIMATE RESET

HINT:

Approximately 50% or more of the automatic transmission fluid has been replaced during a repair of the transmission or a similar operation.

Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE)>INITIALIZATION