Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION WIRE › from 2017.08
RM2660E _52 Drivetrain _066407 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0323653 TRANSMISSION WIRE G

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSPECTION  


PROCEDURE

Hide 82125J 1.INSPECT TRANSMISSION WIRE

a.
C319326E64
2.396,1.74 2.177,0.99 true 1.729,1.74 1.958,0.99 true 1.458,0.281 1.688,0.844 true 2.063,0.281 1.844,0.844 true 0.125,0.073 0.552,0.271 0.427,0.198 10 false *a 1.042,0.063 1.469,0.26 0.427,0.198 10 false OT2- 2.083,0.052 2.51,0.25 0.427,0.198 10 false OT2+ 1.427,1.74 1.74,1.938 0.313,0.198 10 false OT- 2.385,1.75 2.729,1.948 0.344,0.198 10 false OT+

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (OT+) - 4 (OT-) Always 79 Ω to 156 kΩ
5 (OT2+) - 6 (OT2-) Always 25 Ω to 156 kΩ
3 (OT+) - Body ground
5 (OT2+) - Body ground
Always 10 kΩ or higher
4 (OT-) - Body ground
6 (OT2-) - Body ground
Always 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Transmission Wire)

HINT:

If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.


Standard Resistance:
ATF Temperature Specified Condition
10°C (50°F) 5 to 8 kΩ
25°C (77°F) 2.5 to 4.5 kΩ
110°C (230°F) 0.22 to 0.28 kΩ


If the result is not as specified, replace the transmission wire.