Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.
Switch the ECM from normal mode to check mode using the tester (See page Engine / Hybrid System>3UR-FE (ENGINE CONTROL)>SFI SYSTEM(w/ Secondary Air Injection System)>CHECK MODE PROCEDURE).
Perform a simulation test.
Check and wiggle the harness(es), connector(s) and terminal(s).