Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › SFI SYSTEM(w/ Secondary Air Injection System) › from 2017.08
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0327320 SFI SYSTEM(w/ Secondary Air Injection System) C

3UR-FE ENGINE CONTROL  SFI SYSTEM(w/ Secondary Air Injection System)  U0101  Lost Communication with TCM  


DESCRIPTION

The Transmission Control Module (TCM) and ECM perform 2-way communications with each other via the Controller Area Network (CAN). The TCM sends signals to the ECM concerning required engine rpm, required engine torques, warning indicators in the combination meter, DTCs and other data. The ECM sends signals to the TCM concerning engine rpm, opening angles of the throttle valve, temperature of intake air, temperature of engine coolant, engine torques and other data. If the TCM cannot communicate with the ECM, the TCM will conclude that there is a malfunction in the CAN system, illuminate the MIL and store a DTC.

DTC Code DTC Detection Condition Trouble Area
U0101 No communication from TCM continues
·

Open or short in TCM and ECM circuit

·

TCM

·

ECM



PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0101)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Read the DTCs.

Result
Result Proceed to
U0101 is output A
U0101 and other DTCs are output B



A

2.REPLACE ECM

B

2.REPLACE ECM

NEXT

3.CHECK IF DTC RECURS
3.CHECK IF DTC RECURS
a.

Connect the GTS to the DLC3.



c.

Start the engine.


d.

Read the DTCs.

Result
Result Proceed to
No DTC is output A
Other DTCs are output B



A

END

B