Home › Engine / Hybrid System › 3UR-FE (EMISSION CONTROL) › AIR INJECTION DRIVER (w/ Secondary Air Injection System) › from 2017.08
RM2660E _51 Engine / Hybrid System _052787 3UR-FE EMISSION CONTROL _0327530 AIR INJECTION DRIVER(w/ Secondary Air Injection System) A

3UR-FE EMISSION CONTROL  AIR INJECTION DRIVER(w/ Secondary Air Injection System)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY

a.
A177614

Remove the bolt and disconnect the ground wire.


b.

Disconnect the wire harness clamp.


c.
A177613

Disconnect the 4 air injection control driver connectors.


d.
A177615

Remove the 3 bolts and air injection control driver assembly.