Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR AIR CONDITIONING UNIT (w/o Heater) › from 2017.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255672 REAR AIR CONDITIONING UNIT(w/o Heater) A

HEATING / AIR CONDITIONING  REAR AIR CONDITIONING UNIT(w/o Heater)  REASSEMBLY  


PROCEDURE

Hide 88605 1.INSTALL NO. 1 COOLER WIRING HARNESS SUB-ASSEMBLY

Hide 88501R 2.INSTALL EVAPORATOR SUB-ASSEMBLY

E131047

a.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



b.

Install the 2 O-rings to the evaporator.


c.

Install the evaporator.


d.
E154880

Install the rear cooling unit case LH with the 12 screws.


Hide 87103D 3.INSTALL REAR BLOWER MOTOR

E154879

a.

Install the blower motor with the 3 screws.


b.

Connect the connector.


Hide 87165C 4.INSTALL BLOWER MOTOR CONTROLLER

E154812

a.

Install the blower motor controller with the 2 screws.


b.

Connect the connector.


Hide 88515B 5.INSTALL REAR COOLING UNIT EXPANSION VALVE

E383217

a.

Using a 4 mm hexagon wrench, install the expansion valve with the 2 hexagon bolts.

Torque:
3.5 N*m (36 kgf*cm, 31 in.*lbf)


b.

Attach the clamp.


c.

Connect the connector.


Hide 88710C 6.INSTALL AIR CONDITIONER ACCESSORY ASSEMBLY

E154337C01
0.396,2.719 0.813,2.719 false 1,3.219 1.417,3.219 false 0.229,2.625 0.542,2.823 0.313,0.198 10 false *a 0.833,3.135 1.146,3.333 0.313,0.198 10 false *b
*a Bolt
*b Screw


a.

Remove the attached vinyl tape from the air conditioner accessory assembly.


b.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the 2 O-rings to the air conditioner accessory assembly.


d.

Install the air conditioner accessory assembly.


e.

Install the bolt and 2 screws.

Torque:
Bolt : 5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.
E154874

Install new packing as shown in the illustration.


Hide 88539C 7.INSTALL NO. 2 COOLER UNIT DRAIN HOSE

E154791

a.

Attach the claw to install the No. 2 cooler unit drain hose.


b.

Install the screw.


Hide 87217F 8.INSTALL REAR SIDE NO. 3 AIR DUCT

E154873

a.

Install the duct with the 2 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 9.INSTALL COOLING UNIT BRACKET

E154872

a.

Install the bracket with the 2 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)