Home › Audio / Visual / Telematics › GARAGE DOOR OPENER › GARAGE DOOR OPENER SYSTEM › from 2017.08
RM2660E _56 Audio / Visual / Telematics _066408 GARAGE DOOR OPENER _0329611 GARAGE DOOR OPENER SYSTEM G

GARAGE DOOR OPENER  GARAGE DOOR OPENER SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT GARAGE DOOR OPENER

a.
E380216C01
0.635,1.323 0.635,0.906 0.635,0.906 1.448,0.906 true 1.323,1.073 1.469,1.729 1.469,1.729 1.625,1.219 true 1.479,1.135 1.479,1.719 true 0.552,1.323 0.865,1.521 0.313,0.198 10 false *a 1.406,1.76 1.719,1.958 0.313,0.198 10 false *b
*a LED
*b Three "HomeLink" Switches


Press each switch and check that the red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness. If the fuse and wire harness are malfunctioning, replace them. If not, replace the inner rear view mirror assembly (garage door opener).

Click hereVehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>REMOVAL


Hide 2.INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING

HINT:

Use the "HomeLink" tester and a tester transmitter for this test. First clear the customer transmitter code, and then register the tester transmitter code.

Click hereAudio / Visual / Telematics>GARAGE DOOR OPENER>GARAGE DOOR OPENER SYSTEM>REGISTRATION


a.
E380218C01
2.635,1 2.635,0.479 2.635,0.479 3,0.479 true 1.49,1.146 1.49,1.74 true 1.344,1.094 1.49,1.74 1.49,1.74 1.646,1.188 true 3.042,0.406 3.354,0.604 0.313,0.198 10 false *a 1.417,1.76 1.729,1.958 0.313,0.198 10 false *b
*a Tester Transmitter
*b "HomeLink" Switch Press


Check if the test transmitter code was successfully registered.

HINT:
·

Any garage door opener ("HomeLink") switch can be pressed.

·

If the code cannot be registered, replace the inner rear view mirror assembly (garage door opener).

Click hereVehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>REMOVAL




b.
E380219C01
1.281,1.177 1.427,1.958 1.427,1.958 1.615,1.292 true 1.448,1.219 1.427,1.896 false 2.719,2.969 2.719,2.094 2.719,2.094 2.958,2.094 false 1.354,1.979 1.667,2.177 0.313,0.198 10 false *a 3.01,2.021 3.323,2.219 0.313,0.198 10 false *b
*a "HomeLink" Switch Press
*b "HomeLink" Tester


Press a garage door opener ("HomeLink") switch. Check if the green LED of the "HomeLink" tester illuminates.

HINT:

If the green LED does not illuminate, replace the inner rear view mirror assembly (garage door opener).

Click hereVehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>REMOVAL



c.

When the inspection is complete, register the customer transmitter code(s) again.

HINT:
·

Registration of the customer transmitter code(s) may not be possible in the service facility if the transmitters of the customer are not available or if any of the buttons are used for rolling code-type systems.

·

Refer to the Owner's Manual for additional information about registration (programming) of transmitter codes.