Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2017.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255001 SFI SYSTEM D

1GR-FE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


The ECM records vehicle and driving condition information (fuel system information, calculated load, engine coolant temperature, fuel trim, engine speed, vehicle speed, etc.) as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:

If it is impossible to duplicate the problem even though a DTC is output, check the freeze frame data.



A385292E02
2.385,0.271 3.188,0.469 0.802,0.198 10 false DTC stored 2.281,0.885 3.083,1.083 0.802,0.198 10 false 0.5 seconds 1.333,0.885 2.135,1.083 0.802,0.198 10 false 0.5 seconds 0.365,0.885 1.167,1.083 0.802,0.198 10 false 0.5 seconds 0.375,2.802 2.813,3.021 2.438,0.219 10 false Freeze frame data which can be read

The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

-

3 data sets from before the DTC was stored.

-

1 data set from when the DTC was stored.

-

1 data set from after the DTC was stored.


These data sets can be used to simulate the condition of the vehicle from around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.




PENDING FREEZE FRAME DATA


HINT:

Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Select a DTC in order to display its pending freeze frame data.

HINT:
·

Pending freeze frame data is cleared when any of the following occurs.

-

Using the GTS, the DTCs cleared.


-

The cable is disconnected from the negative (-) battery terminal.


-

40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)


·

With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new one of the newly detected DTC in the next trip.



A251781E19
0.156,0.104 6.896,0.594 6.74,0.49 10 false When a DTC is detected in both the first and second trips but the system returns to normal from the third trip (2 trip logic DTC): 0.146,1.625 1.24,1.802 1.094,0.177 10 false Ignition Switch 1.302,1.49 2.115,1.781 0.813,0.292 10 false ON 1.302,1.875 1.552,2.052 0.25,0.177 10 false Off 0.156,2.583 1.198,2.896 1.042,0.313 10 false Pending Freeze Frame Data 1.333,2.531 1.781,2.729 0.448,0.198 10 false Stored 1.323,2.813 1.833,3.135 0.51,0.323 10 false Not Stored 0.125,3.708 1.135,4.438 1.01,0.729 10 false Freeze Frame Data 1.292,3.698 1.74,3.896 0.448,0.198 10 false Stored 0.365,4.698 1.75,4.906 1.385,0.208 10 false :Malfunction detected 0.365,5 2.083,5.208 1.719,0.208 10 false :Malfunction not detected 2.073,0.885 2.76,1.094 0.688,0.208 10 false (First Trip) 2.823,0.885 3.781,1.125 0.958,0.24 10 false (Second Trip) 3.781,0.885 4.74,1.125 0.958,0.24 10 false (Third Trip) 4.594,0.896 5.552,1.135 0.958,0.24 10 false (Fourth Trip) 1.302,3.969 1.813,4.292 0.51,0.323 10 false Not Stored

A251782E21
0.188,0.177 7.063,0.594 6.875,0.417 10 false When 2 trip DTC is first detected in the first trip and another 2 trip DTC is first detected in the second trip: 0.479,1.531 1.396,1.844 0.917,0.313 10 false Ignition Switch 1.781,1.427 2.302,1.646 0.521,0.219 10 false ON 1.781,1.781 2.125,1.958 0.344,0.177 10 false Off 0.479,2.323 1.542,2.688 1.063,0.365 10 false Pending Freeze Frame Data A 0.479,3.271 1.542,3.635 1.063,0.365 10 false Pending Freeze Frame Data B 1.781,2.281 2.24,2.448 0.458,0.167 10 false Stored 1.781,3.188 2.24,3.354 0.458,0.167 10 false Stored 1.781,2.563 2.24,2.958 0.458,0.396 10 false Not Stored 1.781,3.479 2.24,3.875 0.458,0.396 10 false Not Stored 0.677,4.104 3.188,4.344 2.51,0.24 10 false :Pending malfunction A detected 0.677,4.573 3.188,4.813 2.51,0.24 10 false :Pending malfunction B detected 0.677,5.042 2.771,5.271 2.094,0.229 10 false :No malfunction detected 4.198,2.875 5.302,3.052 1.104,0.177 10 false Uploaded 2.635,0.719 3.333,1.031 0.698,0.313 10 false (First Trip) 3.542,0.719 4.677,0.99 1.135,0.271 10 false (Second Trip) 4.604,0.719 5.729,1.052 1.125,0.333 10 false (Third Trip) 5.521,0.719 6.719,1.052 1.198,0.333 10 false (Fourth Trip)



LIST OF FREEZE FRAME DATA


Tester Display
Vehicle Speed
Engine Speed
Calculate Load
Vehicle Load
MAF
Atmosphere Pressure
Coolant Temp
Intake Air
Ambient Temperature
Engine Run Time
Initial Engine Coolant Temp
Initial Intake Air Temp
Battery Voltage
Glow Indicator Supported
Glow Indicator
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
Throttle Sensor Volt %
Throttl Sensor #2 Volt %
Throttle Sensor Position
Throttle Motor DUTY
Throttle Position
ISC Flow
ISC Position
ISC Feedback Value
ISC Learning Value
Electric Load Feedback Val
Air Conditioner FB Val
PS Feedback Val
Low Revolution Control
N Range Status
Eng Stall Control FB Flow
Deposit Loss Flow
Fuel Pump Duty
Injector (Port)
Injection Volum (Cylinder 1)
Current Fuel Type
EVAP (Purge) VSV
Evap Purge Flow
Purge Density Learn Value
EVAP Purge VSV
Purge Cut VSV Duty
Target Air-Fuel Ratio
AF Lambda B1S1
AF Lambda B2S1
AFS Voltage B1S1
AFS Voltage B2S1
AFS Current B1S1
AFS Current B2S1
A/F Heater Duty B1S1
A/F Heater Duty B2S1
O2S B1S2
O2S B2S2
O2 Heater B1S2
O2 Heater B2S2
O2 Heater Curr Val B1S2
O2 Heater Curr Val B2S2
Short FT B1S1
Short FT B1S2
Long FT B1S1
Long FT B1S2
Short FT B2S1
Short FT B2S2
Long FT B2S1
Long FT B2S2
Total FT #1
Total FT #2
A/F Learn Value Idle #1
A/F Learn Value Low #1
A/F Learn Value Mid1 #1
A/F Learn Value Mid2 #1
A/F Learn Value High #1
A/F Learn Value Idle #2
A/F Learn Value Low #2
A/F Learn Value Mid1 #2
A/F Learn Value Mid2 #2
A/F Learn Value High #2
Fuel System Status #1
Fuel System Status #2
Air Pump Pressure (Absolute)
Air Pump2 Pressure (Absolute)
Air Pump Pulsation Pressure
Secondary Air Control VSV
2nd Air System Status
AI Test
Subfreezing Conditions
Air Pump Freeze
Air Switching Valve Freeze
Air Switching Valve2 Freeze
Air Pump Heater
IGN Advance
Knock Feedback Value
Knock Correct Learn Value
Idle Spark Advn Ctrl #1
Idle Spark Advn Ctrl #2
Idle Spark Advn Ctrl #3
Idle Spark Advn Ctrl #4
Idle Spark Advn Ctrl #5
Idle Spark Advn Ctrl #6
VVT Control Status #1
VVT Control Status #2
VVT Advance Fail
Catalyst Temp B1S1
Catalyst Temp B2S1
Catalyst Temp B1S2
Catalyst Temp B2S2
Starter Signal
Power Steering Signal
Neutral Position SW Signal
Clutch Switch
Clutch Start SW
Transfer L4
Stop Light Switch
A/C Signal
Closed Throttle Position SW
Fuel Cut Condition
Immobiliser Communication
TC Terminal
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
Dist Batt Cable Disconnect
IG OFF Elapsed Time
TC and TE1
Total Distance Traveled
Ignition Trig. Count
Cylinder #1 Misfire Count
Cylinder #2 Misfire Count
Cylinder #3 Misfire Count
Cylinder #4 Misfire Count
Cylinder #5 Misfire Count
Cylinder #6 Misfire Count
All Cylinders Misfire Count
Misfire RPM
Misfire Load
Misfire Margin
Catalyst OT MF F/C
Cat OT MF F/C History
Cat OT MF F/C Cylinder#1
Cat OT MF F/C Cylinder#2
Cat OT MF F/C Cylinder#3
Cat OT MF F/C Cylinder#4
Cat OT MF F/C Cylinder#5
Cat OT MF F/C Cylinder#6
Engine Speed (Starter Off)
Starter Count
Run Dist of Previous Trip
Rough Idle Status
Plural Cylinders Rough Idle
Rough Idle #1
Rough Idle #2
Rough Idle #3
Rough Idle #4
Rough Idle #5
Rough Idle #6
Engine Starting Time
Previous Trip Coolant Temp
Previous Trip Intake Temp
Engine Oil Temperature
Previous Trip Eng Oil Temp
Ambient Temp for A/C
Previous Trip Ambient Temp
Engine Start Hesitation
Low Rev for Eng Start
Fuel Cut Elps Time
Power Steering Pressure
ACT VSV
Brake Override System
Idle Fuel Cut
FC TAU
Immobiliser Fuel Cut
Immobiliser Fuel Cut History
Electrical Load Signal 1
Cruise Main SW
Cruise Control Signal
SPD (NT)
SPD (SP2)
Shift SW Status (P Range)
Pattern Switch (PWR/M)
Shift SW Status (R Range)
Shift SW Status (N Range)
Shift SW Status (N,P Range) Supported
Shift SW Status (N,P Range)
Sports Shift Up SW
Sports Shift Down SW
Sports Mode Selection SW
Shift SW Status (D Range)
A/T Oil Temperature 1
A/T Oil Temperature 2
ATF Thermal Degradation Estimate
NT Sensor Voltage
SP2 Sensor Voltage
Lock Up
Shift Status
SLT Solenoid Status
SLU Solenoid Status
Snow or 2nd Start mode
Torque Converter Temperature Raise History