Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255416 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  CALIBRATION  


DESCRIPTION


After replacing the relevant ABS components, clear the sensor calibration data and then perform calibration.

Replacement/Adjustment Part Necessary Operation
Skid control ECU (Master cylinder solenoid) Deceleration sensor zero point calibration
Deceleration sensor
·

Clearing zero point calibration data

·

Deceleration sensor zero point calibration




CLEAR ZERO POINT CALIBRATION


After replacing the deceleration sensor, make sure to clear the zero point calibration data in the skid control ECU (master cylinder solenoid) and perform zero point calibration.

a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Reset Memory.


f.

Using the GTS, perform zero point calibration of the deceleration sensor.



PERFORM ZERO POINT CALIBRATION OF DECELERATION SENSOR


After replacing the master cylinder solenoid and/or deceleration sensor, make sure to perform deceleration sensor zero point calibration.

NOTICE:
·

While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it. Keep it stationary and do not start the engine.

·

Choose a level surface with an inclination of less than 1°.



a.

Procedures for Test Mode:

i.

Turn the ignition switch off.


ii.

for A/T:

Move the shift lever to P.

NOTICE:

DTC C1336 will be stored if the shift lever is not in P.



iii.

for M/T:

Pull the parking brake lever.

NOTICE:

DTC C1336 will be stored if the parking brake lever is not pulled.



iv.

Check that the steering wheel is centered.


v.

Connect the GTS to the DLC3.


vi.

Turn the ignition switch to ON.


vii.

Turn the GTS on.


viii.

Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Test Mode.


ix.

Keep the vehicle stationary on a level surface for 2 seconds or more.


x.

Check that the ABS warning light is blinking in test mode pattern (0.125 seconds on and 0.125 seconds off).

NOTICE:

The ABS warning light stays on when obtaining the zero point.


HINT:
·

If the ABS warning light does not blink, perform the zero point calibration again.

·

The zero point calibration is performed only once after the system enters test mode.

·

Calibration cannot be performed again until the stored data is cleared once.