Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2019.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2111/11  Transmitter ID1 Operation Stop  C2112/12  Transmitter ID2 Operation Stop  C2113/13  Transmitter ID3 Operation Stop  C2114/14  Transmitter ID4 Operation Stop  C2115/15  Transmitter ID5 Operation Stop  


DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter assembly illuminates. The tire pressure warning ECU and receiver stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. The signals can be forcibly transmitted by releasing the tire pressure rapidly. The stored DTC is cleared when signal transmission resumes.

DTC No. DTC Detection Condition Trouble Area
C2111/11
C2112/12
C2113/13
C2114/14
C2115/15
Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver



HINT:

It is necessary to perform the following procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


WIRING DIAGRAM

C339951E14
5.969,3.552 6.406,3.813 0.438,0.26 10 false RDA 5.969,4.01 6.51,4.229 0.542,0.219 10 false PRG 4.333,3.583 4.677,3.75 0.344,0.167 10 false RDA 4.333,3.99 4.677,4.167 0.344,0.177 10 false PRG 5.969,6.531 6.604,6.698 0.635,0.167 10 false CLSW 5.76,6.438 6,6.667 0.24,0.229 10 false 3 5.979,7 6.458,7.167 0.479,0.167 10 false GND 5.698,6.896 5.927,7.063 0.229,0.167 10 false 12 1.771,6.656 2.052,6.823 0.281,0.167 10 false E 2.365,6.656 2.646,6.823 0.281,0.167 10 false INT 1.552,6.438 1.698,6.604 0.146,0.167 10 false 2 2.667,6.427 2.813,6.594 0.146,0.167 10 false 1 5.75,3.917 5.917,4.083 0.167,0.167 10 false 5 5.729,3.417 5.917,3.583 0.188,0.167 10 false 4 5.688,7.802 7.094,8.333 1.406,0.531 10 false Tire Pressure Warning ECU and Receiver 1.052,6.844 1.625,7.01 0.573,0.167 10 false E116 1.052,7.031 3.354,7.333 2.302,0.302 10 false Tire Pressure Warning Reset Switch 2.813,0.167 4.813,0.75 2,0.583 10 false Tire Pressure Warning Valve and Transmitter 0.25,0.75 2.24,1.375 1.99,0.625 10 false Tire Pressure Warning Valve and Transmitter 2.823,1.354 4.823,1.906 2,0.552 10 false Tire Pressure Warning Valve and Transmitter 2.75,2.563 4.76,3.177 2.01,0.615 10 false Tire Pressure Warning Valve and Transmitter 0.271,1.917 2.271,2.469 2,0.552 10 false Tire Pressure Warning Valve and Transmitter 0.917,8.073 2,8.292 1.083,0.219 10 false : Radio Waves 0.719,8.438 2.563,8.656 1.844,0.219 10 false : CAN Communication Line 2.594,5.698 3.042,5.865 0.448,0.167 10 false DLC3 2.594,4.531 4.615,4.76 2.021,0.229 10 false Combination Meter Assembly 2.604,4.844 4.625,5.073 2.021,0.229 10 false - Tire Pressure Warning Light 2.594,3.448 4.229,4.229 1.635,0.781 10 false Main Body ECU (Multiplex Network Body ECU) 4.729,3.417 5,3.583 0.271,0.167 10 false 4 4.729,3.917 4.917,4.083 0.188,0.167 10 false 5 2.156,3.448 2.656,3.615 0.5,0.167 10 false E118 2.167,4.542 2.667,4.708 0.5,0.167 10 false E119 2.167,5.708 2.51,5.875 0.344,0.167 10 false E22 5.688,7.625 7.063,7.781 1.375,0.156 10 false L65

PROCEDURE

1.PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
a.

Set the tire pressure to the specified value (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


g.

Check the values by referring to the table below.

Tire Pressure Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 2 Tire Inflation Pressure ID2 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 3 Tire Inflation Pressure ID3 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 4 Tire Inflation Pressure ID4 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*
ID 5 Tire Inflation Pressure ID5 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*

HINT:
·

*: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25) (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21).




h.

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

i.

Check that each tire pressure value displayed on the GTS has changed.

OK:

Each tire pressure value displayed on the GTS will change to the value of the tire pressure.


NOTICE:
·

It may take a few minutes to display the updated tire pressure data.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

·

The wheel position cannot be determined from ID1 through ID5 on the Data List.




ii.

After confirming that all of the tire pressure data displayed on the GTS has changed, set the tire pressure to the appropriate specified values.

HINT:

If the tire pressure data displayed on the GTS has not changed after rechecking, inspect for another problem (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21).





OK

END

NG

GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE