| *A | except 1GR-FE | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 13 | WINDSHIELD WIPER MOTOR ASSEMBLY | 85110 | ( ) |
- | - |
| *1 | FRONT WIPER LINK | - | - |
Make sure to hold the front wiper arm while lifting it, as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blade.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85292B 1.REMOVE FRONT WIPER ARM HEAD CAP
|
|
|
Remove in this Direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration to remove the front wiper arm head cap.
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut and front wiper arm and blade assembly RH.
While holding the front wiper arm and blade assembly RH, loosen the nut.
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut and the front wiper arm and blade assembly LH.
While holding the front wiper arm and blade assembly LH, loosen the nut.
75533 4.REMOVE WINDSHIELD OUTSIDE MOULDING RH
|
Remove in this Direction |
|
Protective Tape |
Using a clip remover with its tip wrapped with protective tape, detach the clip and remove the windshiled outside moulding RH.
75534 5.REMOVE WINDSHIELD OUTSIDE MOULDING LH
|
Remove in this Direction |
|
Protective Tape |
Using a clip remover with its tip wrapped with protective tape, detach the clip and remove the windshiled outside moulding LH.
51473C 6.REMOVE ENGINE SIDE COVER RH (except 1GR-FE)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
51474B 7.REMOVE ENGINE SIDE COVER LH (except 1GR-FE)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
53383B 8.REMOVE HOOD TO COWL TOP SEAL
55781D 9.REMOVE COWL TOP VENTILATOR LOUVER RH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
55782D 10.REMOVE COWL TOP VENTILATOR LOUVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
55708 11.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
|
|
|
Remove in this Direction | - | - |
12.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
|
|
| *a | Motor Grommet | - | - |
|
Slide in this Direction | - | - |
Remove the 3 bolts.
Detach the motor grommet and remove the front wiper motor and link as shown in the illustration.
Slide the front wiper motor and link toward the outside of the vehicle.
Pull out the front wiper motor and link assembly from the vehicle and disconnect the connector.
85110 13.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
| *a | Wiper Motor Pivot | - | - |
|
Remove in this Direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 1 wiper ring rod from the wiper motor pivot as shown in the illustration.
Using a T30 "TORX" socket wrench, remove the 2 "TORX" screws and the windshield wiper motor assembly.
Do not remove the wiper crank arm from the windshield wiper motor assembly.
Disconnect the connector.