| *A | w/o Power Back Door | *B | w/ Power Back Door |
| *1 | CONNECTOR | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
MP Grease |
85143R 1.INSTALL REAR WIPER MOTOR GROMMET
| *a | Rear Wiper Motor Grommet Lip | *b | Alignment Mark |
|
MP Grease | - | - |
Apply MP grease to the entire surface of the rear wiper motor grommet lip.
Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.
Install the rear wiper motor grommet as shown in the illustration.
Install the rear wiper motor grommet with its alignment mark facing up.
85110R 2.INSTALL REAR WIPER MOTOR ASSEMBLY
64780A 3.INSTALL BACK DOOR TRIM PANEL ASSEMBLY
74811B 4.INSTALL DOOR PULL HANDLE (w/o Power Back Door)
74811G 5.INSTALL DOOR PULL HANDLE (w/ Power Back Door)
64785A 6.INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
67938A 7.INSTALL BACK DOOR SIDE GARNISH LH
67937B 8.INSTALL BACK DOOR SIDE GARNISH RH
67939B 9.INSTALL BACK DOOR CENTER GARNISH
10.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
| *a | Serration | *b | Alignment Mark |
| *c | Wire Brush | - | - |
|
Install in this Direction | - | - |
When reusing the rear wiper arm and blade assembly:
1. Clean the wiper arm serrations to remove any burrs, dirt, etc.
Do not grind down the wiper arm serrations.
2. Clean the wiper pivot serrations with a wire brush.
Do not grind down the wiper pivot serrations.
Set the automatic stop position by the below procedure.
1. Turn the ignition switch to ON.
2. Operate the rear wiper motor assembly and stop it at the automatic stop position.
3. Turn the ignition switch off.
Temporarily install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.
Hold the wiper arm by hand while tightening the nut.
| Area | Measurement |
|---|---|
| A | 10.0 mm (0.394 in.) |
Fully tighten the nut.
Hold the wiper arm by hand while tightening the nut.
Attach the claw and install the rear wiper arm head cap.
11.INSPECT REAR WIPER ARM AND BLADE ASSEMBLY
| *a | Alignment Mark | - | - |
Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not contact the vehicle body.
Lift the wiper arm twice after the wiper stops and check the wiper set position.
| Area | Measurement |
|---|---|
| A | 10 mm (0.394 in.) |