Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0467253 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C455283N02
0.604,2.708 0.688,2.708 0.688,2.708 1,2.51 false 1.583,2.854 1.073,3.51 1.073,3.51 1.24,3.51 false 5.813,1.427 6.125,1.167 6.125,1.167 6.292,1.167 false 6.344,1.021 6.625,1.375 0.281,0.354 18 false 1 1.552,3.385 1.833,3.74 0.281,0.354 18 false 2 0.375,2.625 0.656,2.979 0.281,0.354 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR WHEEL LH - - - -
2 REAR SPEED SENSOR LH 89546 (Click here) - -

*1 CONNECTOR - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL LH

Hide 89546 2.REMOVE REAR SPEED SENSOR LH

Z101186

NOTICE:
·

Remove any dirt or foreign matter on and around the connector before performing this step.

·

Do not allow water, oil or dirt to enter the connector.




a.
C455253N02
0.375,0.063 0.656,0.417 0.281,0.354 18 false i 4.063,0.063 4.344,0.417 0.281,0.354 18 false ii

i.

Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear speed sensor LH.

NOTICE:

Be careful not to damage the rear rear speed sensor LH or connector.



ii.

Remove the nut and the rear speed sensor LH.

NOTICE:
·

Prevent foreign matter from attaching to the sensor tip.

·

The rear speed sensor LH is easily damaged. When pulling out the rear speed sensor LH from the rear axle hub LH, do not use excessive force to rotate and remove it.