Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0467253 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
C457184N02
0.427,3.438 1.417,3.677 0.99,0.24 0.375,3.385 1.458,3.74 1.083,0.354 6.135,1.813 6.406,1.458 6.406,1.458 6.573,1.458 false 1.563,2.865 1.906,3.49 1.906,3.49 2.073,3.49 false 6.583,0.24 6.833,0.24 false 0.594,2.656 0.76,2.656 0.76,2.656 1,2.531 false 0.885,3.427 0.885,3.094 false 6.625,1.302 6.906,1.656 0.281,0.354 18 false 2 2.365,3.333 2.646,3.688 0.281,0.354 18 false 1 6.354,0.083 6.635,0.438 0.281,0.354 18 false 3 0.469,3.469 1.802,3.719 1.333,0.25 8 false 8.3 (85, 73 in.*lbf) 0.385,2.552 0.667,2.906 0.281,0.354 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR SPEED SENSOR LH 89546 (Click here) - -
2 REAR WHEEL LH - - - -
3 CHECK FOR SPEED SENSOR SIGNAL - (Click here) - -

*1 CONNECTOR - -
V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89546 1.INSTALL REAR SPEED SENSOR LH

Z101186

NOTICE:
·

Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

·

Remove any dirt or foreign matter on and around the connector before performing this step.

·

Do not allow water, oil or dirt to enter the connector.




a.
C455254N01
0.365,0.073 0.646,0.427 0.281,0.354 18 false i 4.031,0.094 4.313,0.448 0.281,0.354 18 false ii

i.

Install the rear speed sensor LH with the nut.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)

NOTICE:
·

Keep the tip of the rear speed sensor LH and installation hole free of foreign matter.

·

Firmly insert the rear speed sensor LH body into the rear axle housing before tightening the nut.

·

After installing the rear speed sensor LH to the steering knuckle LH, make sure that there is no clearance between the rear rear speed sensor LH stay and rear axle housing. Also make sure that no foreign matter is stuck between the parts.




ii.

Connect the No. 2 parking brake wire assembly connector to the rear speed sensor LH.



Hide 2.INSTALL REAR WHEEL LH