| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | TRANSMISSION CONTROL CABLE INSULATOR | 33825 | - | - | - |
| 2 | TRANSMISSION CONTROL CABLE ASSEMBLY | 33820B | ( ) |
- | - |
| 3 | PARK/NEUTRAL POSITION SWITCH ASSEMBLY | 84540 | ( ) |
- | - |
| *1 | TRANSMISSION CONTROL SHAFT LEVER RH | - | - |
| ● | Non-reusable part | ★ | Precoated part |
33825 1.REMOVE TRANSMISSION CONTROL CABLE INSULATOR
33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
| *a | Clip | *b | 45° to 60° |
|
Remove in this Direction | - | - |
Remove the clip from the No. 1 transmission control cable bracket.
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever RH together with the clip.
84540 3.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disconnect the park/neutral position switch assembly connector.
Remove the nut, spring washer and transmission control shaft lever RH.
Using a screwdriver, pry out the lock washer.
Be careful not to damage the park/neutral position switch assembly.
Tape the screwdriver tip before use.
Remove the nut and lock washer.
Remove the bolt and park/neutral position switch assembly from the automatic transmission case sub-assembly.
Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.