The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission case oil seal removal/installation are shown below.
36100 1.REMOVE TRANSFER ASSEMBLY
33111F 2.REMOVE TRANSMISSION CASE OIL SEAL
Using SST, remove the transmission case oil seal from the automatic transmission case sub-assembly.
When removing the transmission case oil seal, make sure not to damage the output shaft or automatic transmission case sub-assembly.
33111F 3.INSTALL TRANSMISSION CASE OIL SEAL
Coat the lip of a new transmission case oil seal with a small amount of MP grease.
| *a | 3.2 to 3.8 mm (0.126 to 0.150 in.) |
Using SST and hammer, install the transmission case oil seal to the automatic transmission case sub-assembly.
3.2 to 3.8 mm (0.126 to 0.150 in.)
Keep the transmission case oil seal lip free of foreign matter.
Do not install the transmission case oil seal at an angle.
When installing the transmission case oil seal to the automatic transmission case, do not damage the transmission case oil seal.
36100 4.INSTALL TRANSFER ASSEMBLY
5.ADD AUTOMATIC TRANSMISSION FLUID