| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | INSTALL WIRE HARNESS CLAMP BRACKET | - | - | - | - |
| 2 | NO. 2 GROUND WIRE | 82286A | - | - | - |
| *1 | WIRE HARNESS CLAMP BRACKET | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *A | for V35A-FTS | *B | for 1GR-FE |
| *1 | REAR ENGINE MOUNTING HEAT INSULATOR | *2 | NO. 3 ENGINE MOUNTING HOLE COVER |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| *A | w/ Cover | - | - |
| *1 | FILLER PLUG | *2 | DRAIN PLUG |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
1.INSTALL WIRE HARNESS CLAMP BRACKET
82286A 2.INSTALL NO. 2 GROUND WIRE
36100 3.INSTALL TRANSFER ASSEMBLY
Install the transfer assembly to the automatic transmission assembly with the 8 bolts.
When installing the transfer assembly to the automatic transmission assembly, make sure that the automatic transmission assembly and oil seal do not become damaged.
4.CONNECT WIRE HARNESS AND TRANSFER BREATHER HOSE SUB-ASSEMBLY
33820B 5.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
6.CONNECT WIRE HARNESS CLAMP BRACKET
12371A 7.INSTALL REAR ENGINE MOUNTING INSULATOR
| *A | for V35A-FTS | *B | for 1GR-FE |
| *a | Front Mark | - | - |
for V35A-FTS:
Install the rear engine mounting heat insulator to the rear engine mounting insulator as shown in the illustration.
Make sure that the front mark is facing in the correct direction, and then install the rear engine mounting insulator to the transfer assembly with the 4 bolts.
8.INSTALL NO. 3 FRAME CROSSMEMBER ASSEMBLY (for 1GR-FE)
|
Bolt |
|
Nut |
Install the No. 3 frame crossmember assembly with the 4 nuts and 4 bolts.
Make sure to install the nuts so that they are facing the rear of the vehicle.
Hold the bolts to tighten the nuts.
Connect the rear engine mounting insulator to the No. 3 frame crossmember assembly with the 4 bolts.
9.INSTALL NO. 3 FRAME CROSSMEMBER ASSEMBLY (for V35A-FTS)
|
Bolt |
|
Nut |
Install the No. 3 frame crossmember assembly with the 4 nuts and 4 bolts.
Make sure to install the nuts so that they are facing the rear of the vehicle.
Hold the bolts to tighten the nuts.
Connect the rear engine mounting insulator to the No. 3 frame crossmember assembly with the 4 bolts.
Attach the claw and install the No. 3 engine mounting hole cover to the No. 3 frame crossmember assembly.
36179 11.INSTALL LOWER TRANSFER CASE PROTECTOR
36336 12.INSTALL TRANSFER HEAT INSULATOR
51470 13.INSTALL TRANSMISSION UNDER COVER ASSEMBLY (w/ Cover)
37110F 14.INSTALL REAR PROPELLER SHAFT ASSEMBLY
37140 15.INSTALL FRONT PROPELLER SHAFT ASSEMBLY