Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID (for Bank 1)
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467362 CAMSHAFT OIL CONTROL SOLENOID(for Bank 1) G

V35A-FTS ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID(for Bank 1)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 15370B 1.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY RH (for Intake Side of Bank 1)

a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

According to the display on the GTS, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly RH (for Intake Side of Bank 1).

Powertrain > Engine > Active Test
Tester Display
Control the Intake VVT OCV Duty Ratio Bank 1
50004 372 4
Standard Condition:
GTS Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

Refer to "Data List / Active Test" [Intake VVT Hold Learn Value Bank 1, Intake VVT Change Angle Bank 1, Intake VVT OCV Control Duty Ratio Bank 1 and Intake VVT Target Angle Bank 1].

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST

·

Test not possible with the shift lever in P during charge control. Move the shift lever to N to perform test.

·

If the DTCs are stored after the Active Test, clear the DTCs.



If the result is not as specified, check the cam timing oil control solenoid assembly RH (for Intake Side of Bank 1), wire harness and ECM.


Hide 15370B 2.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY RH (for Exhaust Side of Bank 1)

a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

According to the display on the GTS, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly RH (for Exhaust Side of Bank 1).

Powertrain > Engine > Active Test
Tester Display
Control the Exhaust VVT OCV Duty Ratio Bank 1
50004 372 5
Standard Condition:
GTS Operation Engine Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

Refer to "Data List / Active Test" [Exhaust VVT Hold Learn Value Bank 1, Exhaust VVT Change Angle Bank 1, Exhaust VVT OCV Control Duty Ratio Bank 1 and Exhaust VVT Target Angle Bank 1].

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST

·

Test not possible with the shift lever in P during charge control. Move the shift lever to N to perform test.

·

If the DTCs are stored after the Active Test, clear the DTCs.



If the result is not as specified, check the cam timing oil control solenoid assembly RH (for Exhaust Side of Bank 1), wire harness and ECM.