Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › THROTTLE BODY
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467364 THROTTLE BODY A

V35A-FTS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A474693N01
2.115,0.979 2.635,0.979 false 4.208,1.5 4.208,1.146 false 6.625,0.302 6.865,0.302 false 4.125,1.51 4.313,1.813 0.188,0.302 18 false 3 1.917,0.844 2.083,1.198 0.167,0.354 18 false 2 6.448,0.156 6.635,0.458 0.188,0.302 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 DRAIN ENGINE COOLANT - - (Click here) -
2 INTERCOOLER ASSEMBLY 17940D - - -
3 THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY 22030 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle with throttle position sensor body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 17940D 2.REMOVE INTERCOOLER ASSEMBLY

Hide 22030 3.REMOVE THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY

A474692