Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › MASS AIR FLOW METER
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467383 MASS AIR FLOW METER G

1GR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow meter value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater) and temperature sensing element.



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the value using the GTS.

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to apply suction to the exhaust pipe.



Powertrain > Engine > Data List
Tester Display
Mass Air Flow Sensor
50003 372 215

b.

Wait 30 seconds and read the value on the GTS.

Standard:
Item Condition Specified Condition
Mass Air Flow Sensor
·

Engine not running

·

30 seconds after ignition switch on


0.63 gm/sec. or less


If the result is not as specified, clean (air blow) the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION

After cleaning (air blowing) the mass air flow meter sub-assembly, perform an on-vehicle inspection of the mass air flow meter sub-assembly again and replace the mass air flow meter sub-assembly if the result is not as specified.

If the result is within the specified range, inspect the mass air flow meter.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION