The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.
17140 1.REMOVE EXHAUST MANIFOLD ASSEMBLY RH
17150 2.REMOVE EXHAUST MANIFOLD ASSEMBLY LH
89465A 3.REMOVE HEATED OXYGEN SENSOR (for Bank 1)
Using SST, remove the heated oxygen sensor from the front exhaust pipe.
Do not damage the heated oxygen sensor.
89465 4.REMOVE HEATED OXYGEN SENSOR (for Bank 2)
Using SST, remove the heated oxygen sensor from the front exhaust pipe.
Do not damage the heated oxygen sensor.