|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
89438D 1.INSTALL POWER STEERING OIL PRESSURE SWITCH
Clean the O-ring groove of the power steering oil pressure switch.
Make sure the O-ring groove is free of foreign matter.
Install a new O-ring to the power steering oil pressure switch.
Set the O-ring on the tip of the power steering oil pressure switch and roll it into the O-ring groove with bare hands to install it.
Check if the O-ring is twisted.
Apply a light coat of power steering fluid to the O-ring.
Using a 24 mm deep socket wrench, install the power steering oil pressure sensor.
Connect the power steering oil pressure switch connector.
2.ADD POWER STEERING FLUID
3.BLEED AIR FROM POWER STEERING SYSTEM
4.CHECK FOR POWER STEERING FLUID LEAKAGE