Home › Power Source / Network › NETWORKING › CXPI COMMUNICATION SYSTEM
RM38G0E _57 Power Source / Network _100626 NETWORKING _0467513 CXPI COMMUNICATION SYSTEM L

NETWORKING  CXPI COMMUNICATION SYSTEM  PRECAUTION  


PRECAUTION FOR POWER DISTRIBUTION BOX ASSEMBLY


a.

Do not remove or install the power distribution box assembly with the negative (-) battery terminal connected.

NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting and reconnecting the battery.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





b.

Make sure that the power distribution box assembly is not exposed to water, as it is not waterproof.


c.

Some load is connected to a dedicated circuit to prevent overcurrent. Therefore, parts other than those specified for the vehicle may not be able to be used.


d.

When replacing the power distribution box assembly, the system may not operate normally if the same part number is not used.


e.

Check that systems are operating normally before proceeding with troubleshooting.