Use these procedures to troubleshoot the CXPI communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check for CAN communication system DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Use the GTS to check if the power integration system is functioning normally.
| Result | Proceed to |
|---|---|
| Power integration system DTCs are not output | A |
| Power integration system DTCs are output | B |
A
B
Click herePower Source / Network>POWER DISTRIBUTION>POWER INTEGRATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Data List / Active Test
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT