Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM38G0E _58 Vehicle Interior _100628 SEAT _0467516 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C311  Rear Left Seat Heat Sensor Circuit Short to Ground  B14C315  Rear Left Seat Heat Sensor Circuit Short to Battery or Open  


DESCRIPTION

Output to the rear No. 1 seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C311 Rear Left Seat Heat Sensor Circuit Short to Ground A short to ground in the temperature sensor circuit of the rear left seat heater occurs for 4 seconds or more.
·

Air conditioning amplifier assembly

·

Rear No. 1 seat cushion heater assembly LH

·

Harness or connector


Air Conditioner A
B14C315 Rear Left Seat Heat Sensor Circuit Short to Battery or Open A short to +B or open in the temperature sensor circuit of the rear left seat heater occurs for 4 seconds or more.
·

Air conditioning amplifier assembly

·

Rear No. 1 seat cushion heater assembly LH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396781E27
0.948,1.969 2.51,2.563 1.563,0.594 10 false Air Conditioning Amplifier Assembly 4.271,1.99 5.896,2.583 1.625,0.594 10 false Rear No. 1 Seat Cushion Heater Assembly LH 2.208,0.948 2.729,1.156 0.521,0.208 10 false TFAL 2.219,1.479 2.729,1.708 0.51,0.229 10 false SG-7 2.688,0.813 2.958,1.063 0.271,0.25 10 false 4 0.979,1.771 1.375,2 0.396,0.229 10 false I30 2.688,1.396 2.958,1.552 0.271,0.156 10 false 3 4.26,1.792 4.625,2.063 0.365,0.271 10 false k2 4.271,0.771 4.448,0.969 0.177,0.198 10 false 6 4.281,1.365 4.49,1.583 0.208,0.219 10 false 7

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C311 and B14C315 are not output A
B14C311 or B14C315 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH)

Pre-procedure1

a.

Disconnect the I30 air conditioning amplifier assembly connector.


b.

Disconnect the k2 rear No. 1 seat cushion heater assembly LH connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I30,k2)Location & Routing

Click Connector(I30)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Air Conditioning Amplifier Assembly

Click Connector(k2)Seat>Rear Seat Wire LH>Rear Seat Cushion Heater LH (Rear No. 1 Seat Cushion Pad LH)

I30-4 (TFAL) - k2-6 Always Below 1 Ω
I30-4 (TFAL) or k2-6 - Other terminals and body ground Always 10 kΩ or higher
I30-3 (SG-7) - k2-7 Always Below 1 Ω
I30-3 (SG-7) or k2-7 - Other terminals and body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

d.

None



OK

4.INSPECT REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH

OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE REAR NO. 1 SEAT CUSHION HEATER ASSEMBLY LH