This DTC is output when a malfunction has occurred in the engine pulse signal system from the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| P033531 | Crankshaft Position Sensor "A" No Signal | Start the engine, engine speed is 500 rpm or higher and below 6000 rpm 3 seconds after the ignition switch is turned to ACC, the stereo component equalizer assembly detects a malfunction in the engine pulse signal system for 10 seconds or more continuously* |
·
Harness or connector
·
ECM
·
Stereo component equalizer assembly |
Active Noise Control | A |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
The active noise control system troubleshooting procedure is based on the premise that the stop and start system*, SFI system and entry and start system is operating normally. Check the stop and start system*, SFI system and entry and start system first before troubleshooting the active noise control system.
*: w/ Stop and Start System
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the S25 stereo component equalizer assembly connector.
Disconnect the B1 ECM connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S25,B1)Location & Routingewd_type=routing;type=c,c;code=S25,B1 Click Connector(S25)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=S25;pinno=3 |
||
| S25-3 (NEI) - B1-31 (NEO) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG