Home › Audio / Visual / Telematics › AUDIO / VIDEO › ACTIVE NOISE CONTROL ECU
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0468141 ACTIVE NOISE CONTROL ECU A

AUDIO / VIDEO  ACTIVE NOISE CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E461334N07
1.177,2.771 1.813,2.771 false 4.542,0.563 5.177,0.563 false 1.396,1.188 1.656,0.625 1.656,0.625 2.115,0.625 false 5.76,1.604 6.292,1.604 false 6.594,0.167 6.802,0.167 false 6.417,0.042 6.594,0.323 0.177,0.281 18 false 1 2.198,0.458 2.375,0.781 0.177,0.323 18 false 2 0.979,2.594 1.156,2.917 0.177,0.323 18 false 3 6.354,1.469 6.531,1.792 0.177,0.323 18 false 5 5.24,0.417 5.417,0.74 0.177,0.323 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT CONSOLE BOX - - - -
3 FRONT SEAT ASSEMBLY LH - - - -
4 REAR NO. 1 SEAT ASSEMBLY RH - - - -
5 REAR NO. 1 SEAT ASSEMBLY LH - - - -

E462459N01
0.74,1.854 1,1.854 1,1.854 1.219,1.427 false 0.948,3.292 1.313,3.292 false 3.573,0.573 3.896,0.573 3.896,0.573 4.146,1.021 false 2.167,2.906 2.375,2.906 false 3.333,3.125 3.615,3.125 3.615,3.125 3.667,2.927 false 5.26,2.917 5.521,2.917 5.521,2.917 5.688,3.25 false 5.958,1.521 6.219,1.521 false 6.656,2.594 6.656,3.115 false 5.083,0.74 5.344,0.74 false 3.156,2.719 3.417,2.719 false 3.979,3.042 3.979,3.25 false 0.781,0.281 1.24,0.479 0.458,0.198 10 false x 3 3.594,2.125 4.052,2.323 0.458,0.198 10 false x 2 5.042,2.771 5.25,3.083 0.208,0.313 18 false 6 6.604,3.135 6.771,3.438 0.167,0.302 18 false 8 3.385,0.448 3.552,0.75 0.167,0.302 18 false 9 1.354,3.135 1.521,3.438 0.167,0.302 18 false 7 5.365,0.583 5.688,0.865 0.323,0.281 18 false 10 6.25,1.375 6.583,1.646 0.333,0.271 18 false 11 3.906,3.281 4.167,3.469 0.26,0.188 10 false *2 0.396,1.708 0.719,1.979 0.323,0.271 18 false 12 2.979,2.646 3.188,2.833 0.208,0.188 10 false *1 1.719,1.833 2,2.083 0.281,0.25 12 false *A 2.833,1.833 3.115,2.083 0.281,0.25 12 false *B 4.365,3.208 4.823,3.406 0.458,0.198 10 false x 2 3.156,2.24 3.396,2.438 0.24,0.198 10 false x 2 2.406,2.771 2.729,3.042 0.323,0.271 18 false 13 2.99,2.979 3.313,3.25 0.323,0.271 18 false 13

Procedure Part Name Code
Z101186

Z101188

Z101187

6 FRONT DOOR SCUFF PLATE LH 67914B - - -
7 COWL SIDE TRIM BOARD LH 62112 - - -
8 REAR DOOR SCUFF PLATE LH 67918D - - -
9 OUTER LAP BELT ANCHOR COVER 73233 - - -
10 FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) 73220 - - -
11 CENTER PILLAR LOWER GARNISH LH 62414A - - -
12 FRONT FLOOR CARPET ASSEMBLY 58510D - - -
13 STEREO COMPONENT EQUALIZER ASSEMBLY 86240A - - -

*A for Type A *B for Type B
*1 NO. 1 STEREO COMPONENT EQUALIZER BRACKET *2 NO. 2 STEREO COMPONENT EQUALIZER BRACKET

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the stereo component equalizer assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click here(Click here)



Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 4.REMOVE REAR NO. 1 SEAT ASSEMBLY RH

Hide 5.REMOVE REAR NO. 1 SEAT ASSEMBLY LH

Hide 67914B 6.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 7.REMOVE COWL SIDE TRIM BOARD LH

Hide 67918D 8.REMOVE REAR DOOR SCUFF PLATE LH

Hide 73233 9.REMOVE OUTER LAP BELT ANCHOR COVER

Hide 73220 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)

Hide 62414A 11.REMOVE CENTER PILLAR LOWER GARNISH LH

Hide 58510D 12.REMOVE FRONT FLOOR CARPET ASSEMBLY

Hide 86240A 13.REMOVE STEREO COMPONENT EQUALIZER ASSEMBLY

a.

for Type A:

E461345


b.

for Type B:

E466242