ENTER DIAGNOSTIC MODE
Enter diagnostic mode.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
COLOR BAR CHECK
Use the switch of television display assembly for each inspection.
This mode checks the color display on the television display assembly.
Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.
Select "Color Bar Check" from the "REAR Check" screen.
Select "Color Bar Check" from the "REAR Check" screen.
Select a color bar from the "Color Bar Check" screen.
Check the display color.
The entire screen turns to the color or stripe which is selected.
The screen returns to the "Color Bar Check" screen if the switch of television display assembly is operated again.
TOUCH SW CHECK
Use the switch of television display assembly for each inspection.
The touch switches on the screen are checked in the following procedure.
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.
Select "Touch SW Check".
Touch Switch Check.
Touch the display anywhere in the open areato perform the check when the "Touch SW Check" screen is displayed.
HARDWARE KEY CHECK
Use the switch of television display assembly for each inspection.
The television display assembly panel switches are checked in thefollowing procedure.
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.
Select "Hardware Key Check".
Hardware Key Check.
Operate each switch and check that the switch conditions are correctly displayed.
FINISH DIAGNOSTIC MODE
Turn the ignition switch off.