The radio receiver assembly and multi-display controller are connected by GVIF cable.
When a GVIF cable error occurs between the radio receiver assembly and multi-display controller, this DTCs will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1577 | GVIF Disconnected (from EMV/MM Integrated Device to RSE) | GVIF disconnected (from multi-media module receiver assembly to multi-display controller) |
·
Harness or connector (GVIF cable)
·
Multi-display controller
·
Radio receiver assembly |
Navigation System | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
w/ Navigation System: Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
w/o Navigation System: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type, for 12.3 Inch Display)>PRECAUTION
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTC are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the I138 radio receiver assembly connector.
Disconnect the Q65 multi-display controller connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I138,Q65)Location & Routingewd_type=routing;type=c,c;code=I138,Q65 Click Connector(Q65)Seat>Floor Wire>Multi-Display Controllerewd_type=component;type=c;code=Q65;pinno=1,2,3 |
||
| I138-1 (GVI-) - Q65-1 (GVO-) | Always | Below 1 Ω |
| I138-2 (GVI+) - Q65-2 (GVO+) | Always | Below 1 Ω |
| I138-3 (GVG2) - Q65-3 (GVG2) | Always | Below 1 Ω |
| I138-1 (GVI-) - Body ground | Always | 10 kΩ or higher |
| I138-2 (GVI+) - Body ground | Always | 10 kΩ or higher |
| I138-3 (GVG2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None.
OK
NG
Replace the multi-display controller with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTC are not output | A |
| DTCs are output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL