The main body ECU (multiplex network body ECU) communicates with the windshield wiper motor assembly and rain sensor via LIN communication. If a malfunction occurs in the LIN communication line and a communication error occurs, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B276C88 | Alarm / Wiper LIN Bus off |
DTC Detection Condition:
Ignition switch ON (IG+ voltage 9.5 V or higher)
Malfunction Status:
Wire-type LIN communication error detected
Malfunction Duration:
7 seconds or more |
·
Main body ECU (multiplex network body ECU)
·
Map light assembly
·
Rain sensor
·
Harness or connector |
○ | Main Body | A |
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Turn the ignition switch to ON and wait for at least 10 seconds.
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| B276C88 is not output. | A |
| B276C88 is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B