Home › Audio / Visual / Telematics › TELEMATICS › TELEPHONE MICROPHONE ASSEMBLY
RM38G0E _56 Audio / Visual / Telematics _100608 TELEMATICS _0467769 TELEPHONE MICROPHONE ASSEMBLY A

TELEMATICS  TELEPHONE MICROPHONE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E462410N01
2.271,0.906 2.854,0.906 false 6.417,0.198 6.833,0.198 false 4.417,2.25 4.906,2.75 4.906,2.75 5.333,2.75 false 6.25,0.042 6.531,0.396 0.281,0.354 18 false 1 5.385,2.563 5.667,2.917 0.281,0.354 18 false 2 2.083,0.75 2.365,1.104 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 ROOF HEADLINING ASSEMBLY - - - -
3 TELEPHONE MICROPHONE ASSEMBLY 86730A - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the telephone microphone assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click here(Click here)



Hide 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86730A 3.REMOVE TELEPHONE MICROPHONE ASSEMBLY

a.
E462424