| *A | for Standard | *B | for Aero Type |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | ULTRASONIC SENSOR CUSHION SET | 89305 | ( ) |
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ultrasonic sensor (for Rear) removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE REAR BUMPER ASSEMBLY
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Aero Type)>REMOVAL
89348D 2.REMOVE ULTRASONIC SENSOR CLIP (for Standard)
The orientation for the RH side is the opposite of the LH side.
89342 3.REMOVE REAR CORNER ULTRASONIC SENSOR
for Standard:
for Aero Type:
The orientation for the RH side is the opposite of the LH side.
89342A 4.REMOVE REAR CENTER ULTRASONIC SENSOR
The orientation for the RH side is the opposite of the LH side.
89C48A 5.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER
|
|
| Part | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60 °C (104 to 140 °F) |
| Rear Corner Ultrasonic Sensor Retainer | 40 to 60 °C (104 to 140 °F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper assembly and rear corner ultrasonic sensor retainer excessively.
| *A | for Standard | *B | for Aero Type |
Heat the adhesive of the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.
Remove the rear corner ultrasonic sensor retainer.
The orientation for the RH side is the opposite of the LH side.
89C48B 6.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER
|
|
| Part | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60 °C (104 to 140 °F) |
| Rear Center Ultrasonic Sensor Retainer | 40 to 60 °C (104 to 140 °F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear bumper assembly and rear center ultrasonic sensor retainer excessively.
| *A | for Standard | *B | for Aero Type |
Heat the adhesive of the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.
Remove the rear center ultrasonic sensor retainer.
The orientation for the RH side is the opposite of the LH side.
89305 7.REMOVE ULTRASONIC SENSOR CUSHION SET
|
|
|
Remove in this Direction | - | - |