Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467882 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B612020N01
6.615,0.198 6.865,0.198 true 4.448,2.167 4.448,2.5 true 6.49,0.042 6.771,0.396 0.281,0.354 18 false 1 4.375,2.458 4.656,2.813 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 ROOF HEADLINING ASSEMBLY - - - -

B608770N01
1.917,0.083 5.25,1.833 3.333,1.75 1.917,1.917 5.25,3.667 3.333,1.75 3,0.313 3.25,0.313 true 3.021,2.167 3.271,2.167 true 3.51,0.833 3.51,1.104 true 3.521,2.688 3.521,2.958 true 3.448,2.927 3.729,3.281 0.281,0.354 18 false 4 3.438,1.073 3.719,1.427 0.281,0.354 18 false 3 1.99,0.115 2.365,0.354 0.375,0.24 12 false *A 2.906,0.208 3.063,0.406 0.156,0.198 10 false ● 2.927,2.063 3.083,2.26 0.156,0.198 10 false ● 3.177,0.396 3.792,0.594 0.615,0.198 10 false x 14 3.24,2.24 3.854,2.438 0.615,0.198 10 false x 9 1.99,1.969 2.365,2.208 0.375,0.24 12 false *B

Procedure Part Name Code
Z101186

Z101188

Z101187

3 CURTAIN SHIELD AIRBAG ASSEMBLY LH 62180A (Click here) - -
4 CURTAIN SHIELD AIRBAG ASSEMBLY LH 62180A (Click here) - -

*A for 7-Passenger *B for 5-Passenger
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 62180A 3.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for 7-Passenger)

Z101186

CAUTION:
·
B399183N02
1.313,1.313 1.313,0.938 false 0.667,0.5 0.823,0.698 0.156,0.198 10 false . 1.26,1.333 1.573,1.531 0.313,0.198 10 false *a

When storing the curtain shield airbag assembly LH, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B608773N01
0.448,0.052 0.729,0.406 0.281,0.354 18 false i 0.135,1.99 0.417,2.344 0.281,0.354 18 false ii 0.385,3.917 0.667,4.271 0.281,0.354 18 false iii

i.

Disconnect the 2 airbag connectors.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the 14 bolts.


iii.

Disengage the claw, hook and clip to remove the curtain shield airbag assembly LH.

NOTICE:
·

When removing the curtain shield airbag assembly LH, make sure not to peel or tear the tape attached to it.

·

When removing the curtain shield airbag assembly LH, make sure not to cause deformation to its resin case.



HINT:

A clip is not necessarily used as reassembly is no longer necessary once the clip is damaged during removal and installation of the curtain shield airbag assembly LH.




Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for 5-Passenger)

Z101186

CAUTION:
·
B399183E01
1.313,1.313 1.313,0.938 false 0.667,0.5 0.823,0.698 0.156,0.198 10 false . 1.26,1.333 1.573,1.531 0.313,0.198 10 false *a

When storing the curtain shield airbag assembly LH, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B608775N01
2.125,0.052 2.406,0.406 0.281,0.354 18 false i 0.146,1.833 0.427,2.188 0.281,0.354 18 false ii 0.396,3.906 0.677,4.26 0.281,0.354 18 false iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the 9 bolts.


iii.

Disengage the claw and hook to remove the curtain shield airbag assembly LH.

NOTICE:
·

When removing the curtain shield airbag assembly LH, make sure not to peel or tear the tape attached to it.

·

When removing the curtain shield airbag assembly LH, make sure not to cause deformation to its resin case.