| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | EVAPORATOR SUB-ASSEMBLY (REAR) | 88501R | ( ) |
- | - |
| *1 | COOLING UNIT CASE LH | *2 | COOLING UNIT CASE RH |
| ● | Non-reusable part | - | - |
87217E 1.REMOVE REAR NO. 2 SIDE AIR DUCT
88688Z 2.REMOVE BRACKET
87165C 3.REMOVE BLOWER MOTOR CONTROL
87236C 4.REMOVE HEATER BLOWER COVER
87103D 5.REMOVE REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
88561P 6.REMOVE REAR NO. 1 AIR CONDITIONING UNIT PACKING
88G10B 7.REMOVE NO. 6 AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the screw.
Remove the bolt and No. 6 air conditioning tube and accessory assembly.
Remove the 2 O-rings from the No. 6 air conditioning tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88605 8.REMOVE NO. 1 COOLER WIRING HARNESS SUB-ASSEMBLY
88515B 9.REMOVE REAR COOLING UNIT EXPANSION VALVE
Detach the clamp.
Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and rear cooling unit expansion valve.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88F88G 10.REMOVE REAR NO. 1 AIR CONDITIONING UNIT BRACKET
88501R 11.REMOVE EVAPORATOR SUB-ASSEMBLY (REAR)
Remove the 12 screws.
Detach the claw and remove the cooling unit case LH.
|
Remove in this Direction | - | - |
Remove the evaporator sub-assembly (rear) as shown in the illustration.
Remove the 2 O-rings from the evaporator sub-assembly (rear).
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.