| *1 | AIR CONDITIONING PRESSURE SENSOR COVER | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Compressor oil ND-OIL 8 or equivalent | - | - |
88719A 1.INSTALL AIR CONDITIONING PRESSURE SENSOR
| *a | Turn | *b | Hold |
Remove the attached vinyl tape from the air conditioning pressure sensor installation area of the air conditioning tube and accessory assembly and then apply a sufficient amount of compressor oil to the fitting surface of a new air conditioning pressure sensor O-ring and the air conditioning tube and accessory assembly.
ND-OIL 8 or equivalent
Keep the O-ring and O-ring fitting surface free of foreign matter.
Using a 27 mm deep socket wrench, install the air conditioning pressure sensor.
Do not apply excessive force to the air conditioning tube and accessory assembly.
Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed.)
Install the air conditioning pressure sensor cover.
Connect the connector.
3.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
4.WARM UP COMPRESSOR
5.INSPECT FOR REFRIGERANT LEAK
53292A 6.INSTALL UPPER RADIATOR SUPPORT SEAL