Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR GLASS
RM38G0E _59 Vehicle Exterior _100827 MIRROR (EXT) _0468033 OUTER REAR VIEW MIRROR GLASS A

MIRROR (EXT)  OUTER REAR VIEW MIRROR GLASS  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B607281N01
5.042,1.875 5.615,1.875 true 5.854,1.729 6.135,2.083 0.281,0.354 18 true 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 OUTER MIRROR LH 87961 (Click here) - -

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 87961 1.REMOVE OUTER MIRROR LH

a.
B607282C01
1.125,0.146 1.302,0.427 0.177,0.281 18 true i 4.677,0.146 4.885,0.427 0.208,0.281 18 true ii 2.875,2.542 3.188,2.844 0.313,0.302 18 true iii
V113147

Move in this Direction - -


i.

Apply protective tape to the areas shown in the illustration.


ii.

Using moulding remover D, detach the claw on the lower part of the outer mirror LH as shown in the illustration.

NOTICE:

Do not forcibly pull on the outer mirror LH as the unit drive may detach, or the mirror surface part may break.



iii.

Using moulding remover D, detach the claw on the upper part of the outer mirror LH as shown in the illustration.

HINT:

The claw will reattach if excessive force is applied when pushing down the mirror surface.




b.
B607283C02
1.292,0.958 1.438,1.25 0.146,0.292 18 true i 4.177,0.052 4.427,0.333 0.25,0.281 18 true iii 1.385,0.99 1.76,1.25 0.375,0.26 12 true (*C) 3.625,0.052 3.833,0.302 0.208,0.25 18 true ii 3.75,0.083 4.167,0.313 0.417,0.229 12 true (*A), 4.417,0.083 4.833,0.323 0.417,0.24 12 true (*B)
*A w/ Blind Spot Monitor System *B w/ EC Mirror
*C w/ Mirror Heater - -


i.

w/ Mirror Heater:

1. Disconnect the mirror heater connector.

NOTICE:
·

Do not raise the claw higher than is necessary as it will damage the claw of the terminal.

·

If the claw of the connector is damaged, replace the outer mirror LH with a new one.

·

If there is damage to the wire harness or an open circuit has occurred, replace the outer rear view mirror assembly LH with a new one.




ii.

w/ Blind Spot Monitor System:

1. Detach the clamp.

2. Disconnect the blind spot monitor indicator connector to remove the outer mirror LH.


iii.

w/ EC Mirror:

1. Detach the clamp.

2. Disconnect the EC mirror connector to remove the outer mirror LH.