| *1 | REAR AXLE BEARING INNER RETAINER LH | *2 | REAR AXLE SHAFT WASHER LH |
| *3 | PARKING BRAKE PLATE TO REAR AXLE HOUSING BOLT | *4 | PARKING BRAKE PLATE SUB-ASSEMBLY LH |
| *5 | REAR AXLE HUB BOLT LH | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides
The following procedure is for the LH side.
42312D 1.REMOVE REAR AXLE SHAFT SNAP RING LH
Using a snap ring expander, remove the rear axle shaft snap ring LH.
42312 2.REMOVE REAR AXLE SHAFT LH
Using SST and a press, press out the rear axle shaft LH and rear axle bearing inner retainer LH and rear axle shaft washer LH.
Be careful not to drop the axle shaft.
Grind the rear axle bearing inner race surface using a grinder, then remove it with a chisel.
Do not damage the rear axle shaft.
42450B 3.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
Temporarily install 4 nuts to the housing bolts.
Using a hammer, remove the 4 housing bolts and rear axle hub and bearing assembly LH.
Remove the 4 nuts.
42441B 4.REMOVE BRAKE DRUM OIL DEFLECTOR LH
Using SST, remove the 6 hub bolts.
Do not deform the oil deflector.
Make sure to align the notch of SST with the flange of the oil deflector.
Remove the brake drum oil deflector LH and brake drum oil deflector gasket LH from the rear axle shaft LH.