| *1 | REAR AXLE BEARING INNER RETAINER LH | *2 | PARKING BRAKE PLATE TO REAR AXLE HOUSING BOLT |
| *3 | PARKING BRAKE PLATE SUB-ASSEMBLY LH | *4 | REAR AXLE HUB BOLT LH |
| ● | Non-reusable part | - | - |
Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
42441B 1.INSTALL BRAKE DRUM OIL DEFLECTOR LH
| *a | Oil Drain Hole | - | - |
Install a new brake drum oil deflector gasket LH and the brake drum oil deflector LH to the rear axle shaft.
Align the 2 oil drain holes.
Temporarily install a washer and nut to 6 new hub bolts as shown in the illustration.
Install the hub bolts by tightening each nut.
Remove the washer and nut from each hub bolt.
42450B 2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
Position the parking brake plate on a new rear axle hub and bearing.
Make sure to securely fit the parking brake plate to the bearing.
Using 2 socket wrenches and a press, press in the 4 housing bolts.
42312 3.INSTALL REAR AXLE SHAFT LH
| *a | Tapered Surface | *b | Chamfered Surface |
Install the washer and a new retainer to the axle hub as shown in the illustration.
Install the washer with its tapered surface facing downward.
Install the retainer with its chamfered surface facing downward.
Using SST and a press, press in the rear axle shaft LH.
Make sure to securely fit the bearing to the rear axle shaft LH.
42312D 4.INSTALL REAR AXLE SHAFT SNAP RING LH