| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT FENDER MOULDING SUB-ASSEMBLY LH | 75602A | ( ) |
- | - |
| 2 | FRONT FENDER WHEEL ORNAMENT PAD | - | ( ) |
- | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75602A 1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
|
| Part | Temperature |
|---|---|
| Front Fender Moulding Sub-assembly LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender moulding sub-assembly LH excessively.
| *a | Double-sided Tape | - | - |
|
Screw |
|
Clip |
Put protective tape around the front fender moulding sub-assembly LH.
Using a 4 mm hexagon socket wrench, remove the 2 screws.
Remove the 5 clips.
Insert a screwdriver with its tip wrapped with protective tape into the gap and detach the claw.
Heat the adhesive of the front fender moulding sub-assembly LH using a heat light.
Using moulding remover B, detach the clip and double-sided tape in the order shown in the illustration and remove the front fender moulding sub-assembly LH as shown in the illustration.
Detach the clip one by one.
2.REMOVE FRONT FENDER WHEEL ORNAMENT PAD
|
|
| Part | Temperature |
|---|---|
| Front Fender Wheel Ornament Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender wheel ornament pad excessively.
Heat the adhesive of the front fender wheel ornament pad using a heat light.
Remove the front fender wheel ornament pad.