| *A | w/ Power Back Door | *B | w/o Power Back Door |
| ● | Non-reusable part | - | - |
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
76085 1.INSTALL REAR SPOILER SUB-ASSEMBLY
64886B 2.INSTALL BACK DOOR GLASS CHANNEL LH (w/o Power Back Door)
|
|
| Part | Temperature |
|---|---|
| Back Door Panel | 40 to 60 °C (104 to 140 °F) |
| Back Door Glass Channel LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the back door panel excessively.
|
Double-sided Tape | - | - |
Clean the back door panel surface.
1. When reusing the back door panel, remove remaining double-sided tape from the back door panel.
2. Using a heat light, heat the back door panel surface.
3. Remove any remaining double-sided tape from the back door panel and wipe off any tape adhesive residue with cleaner.
4. Clean the installation area surface.
Installing the back door glass channel LH with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
Using a heat light, heat the back door panel and a new back door glass channel LH.
Do not heat the back door glass channel LH and back door panel.
Attach the claw of the back door glass channel LH and install the back door glass channel LH.
The application strength of the back door glass channel LH will weaken if reapplied. If reapplication is necessary, be sure to replace it with a new one.
Apply pressure so that it does not lift up from the back door panel.
Install the clip.
64885C 3.INSTALL BACK DOOR GLASS CHANNEL RH (w/o Power Back Door)
Use the same procedure described for LH side.
4.INSTALL HOLE PLUG
67939B 5.INSTALL BACK DOOR CENTER GARNISH
85345R 6.INSPECT REAR WASHER NOZZLE