| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | ROOF RACK LEG PLATE | 63479C | ( ) |
- | - |
| 3 | ROOF RACK ASSEMBLY | - | ( ) |
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
1. PRECAUTION
|
|
63479C 2.INSTALL ROOF RACK LEG PLATE
|
|
| Part | Temperature |
|---|---|
| Roof Rack Assembly | 40 to 60°C (104 to 140°F) |
| Roof Rack Leg Plate | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the roof rack leg plate and roof rack assembly excessively.
Clean the roof rack assembly surface:
1. When reusing the roof rack assembly, remove remaining double-sided tape from the roof rack assembly.
2. Using a heat light, heat the roof rack assembly surface.
3. Remove any remaining double-sided tape from the roof rack assembly and wipe off any tape adhesive residue with cleaner.
4. Clean the installation area surface.
Installing the roof rack leg plate with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
Also, clean a new roof rack assembly surface.
Using a heat light, heat the roof rack assembly and a new roof rack leg plate.
Install the roof rack leg plate in the position shown in the illustration.
The application strength of the roof rack leg plate will weaken if reapplied. If reapplication is necessary, be sure to replace it with a new one.
Apply pressure so that it does not lift up from the roof rack assembly.
3.INSTALL ROOF RACK ASSEMBLY
Install the new 12 bolts and roof rack assembly.
When roof rack leg and roof rack support are removed:
|
Bolt |
|
Nut |
Tighten 18 bolts and 6 nuts that are temporarily tightened.