| *1 | WINCH BASE | *2 | FRONT BASE MEMBER |
| *3 | SNAP RING | - | - |
| *1 | CABLE TIE | *2 | WIRE |
| *3 | BRACKET A | *4 | BRACKET B |
| ● | Non-reusable part | - | - |
| *1 | END FRAME | - | - |
| ● | Non-reusable part | - | - |
38380 1.REMOVE WINCH HOOK HOLDER ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) | - | - |
2.REMOVE WINCH HOOK
Using a snap ring expander, remove the snap ring and winch hook.
38360 3.REMOVE WINCH ROLLER BRACKET ASSEMBLY
38600A 4.REMOVE WINCH WITH MAGNET SWITCH MOTOR ASSEMBLY
| *a | Bolt A | *b | Bolt B |
| *c | Bolt C | *d | Bolt D |
82295 5.REMOVE WINCH EARTH WIRE
38621B 6.REMOVE MAGNET SWITCH WINCH COVER
38610A 7.REMOVE WINCH MOTOR ASSEMBLY
Remove the 2 nuts, 2 washers and 2 spring washers.
Disconnect the connector and cut the 2 cable tie.
Remove the 4 bolts and winch motor assembly.
38623 8.REMOVE WINCH MOTOR STOPPER
38611B 9.REMOVE WINCH MOTOR MAGNET SWITCH
38639 10.REMOVE WINCH MOTOR WIRE
38625 11.REMOVE STUD WINCH MOTOR BOLT
38627 12.REMOVE STEPPED MALE WINCH MOTOR BUSHING
38629 13.REMOVE WINCH MOTOR WIRE
38618 14.REMOVE WINCH MOTOR COMMUTATOR END FRAME
28199B 15.REMOVE DUST WINCH MOTOR PROTECTOR
38614A 16.REMOVE WINCH MOTOR O-RING
38613A 17.REMOVE WINCH MOTOR BRUSH
Using a screwdriver, pry the winch motor bush spring forward and pull the winch motor brush out of the winch motor brush holder assembly.
Remove the screw and winch motor brush from the winch motor brush holder assembly.
Remove the 3 remaining brushes using the same procedure.
38604A 18.REMOVE WINCH MOTOR BRUSH HOLDER ASSEMBLY
|
Remove in this Direction | - | - |
38601A 19.REMOVE WINCH MOTOR YOKE SUB-ASSEMBLY
|
Remove in this Direction | - | - |
38603A 20.REMOVE WINCH MOTOR ARMATURE SUB-ASSEMBLY
|
Remove in this Direction | - | - |
38603B 21.REMOVE NO. 1 WINCH MOTOR ARMATURE BEARING
Using SST, remove the No. 1 winch motor armature bearing.
38603C 22.REMOVE NO. 2 WINCH MOTOR ARMATURE BEARING
Using SST, remove the No. 2 winch motor armature bearing.
38613B 23.REMOVE WINCH MOTOR BRUSH SPRING
| *a | Screwdriver A | *b | Screwdriver B |
|
Remove in this Direction | - | - |
Insert a screwdriver labeled A as shown in the illustration and pry the winch motor brush spring forward, and then move the winch motor brush spring in the direction of the arrow shown in the illustration with a screwdriver labeled B to remove it from the holder.