The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below.
When replacing the forward recognition camera, replace it with a new one.
Replace the forward recognition camera if there is any foreign matter on the camera lens.
Do not touch the camera lens or the front windshield glass in front of the camera.
If the forward recognition camera has been struck or dropped, replace it with a new one.
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also the dynamic radar cruise control system, front camera system, lane tracing assist system, lane departure alert system, road sign assist system, pre-collision system, adaptive high beam system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86466E 1.REMOVE NO. 2 FORWARD RECOGNITION COVER
|
|
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Move in this Direction | - | - |
Move the inner rear view mirror assembly.
Using moulding remover A, detach the claw.
Detach the guide and remove the No. 2 forward recognition cover.
86466D 2.REMOVE NO. 1 FORWARD RECOGNITION COVER
|
|
|
Place Your Finger Here |
|
Remove in this Direction |
86464A 3.REMOVE FORWARD RECOGNITION LATCH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
8646C 4.REMOVE FORWARD RECOGNITION CAMERA
|
|
|
Remove in this Direction | - | - |