| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY | 86401 | ( ) |
- | - |
| 2 | FORWARD RECOGNITION CAMERA | 8646C | - | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86401 1.INSTALL FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY
|
|
| *a | Connector Clamp | *b | Guide |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
|
Heater Area | - | - |
Insert the forward recognition with heater hood sub-assembly in the direction indicated by the arrow (1) in the illustration to attach the guide.
Attach the claw in the direction indicated by the arrow (2) in the illustration.
Make sure that the 2 claws are attached as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.
Do not apply force to the heating element of the forward recognition with heater hood sub-assembly or an open circuit may result.
Install the wire harness to the guide.
Make sure that the clamp and 2 guides are attached as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.
Attach the connector clamp to install the forward recognition with heater hood sub-assembly.
As the No. 1 forward recognition cover cannot be installed correctly if the connector clamp is not attached securely, make sure to attach the connector clamp securely.
Connect the connector.
8646C 2.INSTALL FORWARD RECOGNITION CAMERA